Recent experimental studies suggest that the use of suture anchors for rotator cuff tear (RCT) repair transfers the "weak link" to the suture-tendon interface where failure occurs as the sutures cut through the tendon. The purpose of this study was to evaluate the effect of using a suture augmentation button on the fixation strength of rotator cuff tendon repair. A 1.5 cm by 2 cm defect was created in the supraspinatus tendon of seven cadaveric shoulder pairs and two suture anchors inserted in each humerus for suture attachment. For one of each pair, the defect was repaired with sutures placed in a horizontal mattress configuration. The other side was repaired with the sutures being passed through low profile, bioabsorbable buttons placed on the bursal tendon surface prior to knot tying. The supraspinatus tendon was cyclically loaded at a physiologic rate and load (33 mm/sec and 180 N, respectively). The number of loading cycles was recorded when the specimens developed 0.75 cm and 1.5 cm gaps at the repair site. The specimens were then tested to failure. Specimens in the unaugmented group developed 0.75 cm and 1.5 cm gaps at an average of 135 cycles and 362 cycles, respectively. The button augmented group developed these gaps at average of 420 cycles and 708 cycles, respectively. These differences were statistically significant (p < 0.05). The gaps progressively increased in all specimens, which eventually failed by suture cutting through tendon in all specimens. This study demonstrates that in vitro, suture augmentation with a low profile, bioabsorbable button provides significantly enhanced fixation when using suture anchors to repair torn rotator cuff tendon. This device may be a useful adjunct to current methods of rotator cuff repair.